JN0-451 Mist AI - Specialist (JNCIS-MistAI) Questions and Answers

According to the Cisco Catalyst 9800 Series Wireless Controller Software Configuration Guide2, a non-compliant AP is an AP that has a different hardware model than what is expected by the cloud configuration. This can happen when an AP is replaced with an incorrect model or when an AP is moved to a different site group that has a different hardware model requirement. The solution is to replace the AP with the correct hardware model.

References: https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-2/config-guide/b_wl_17_2_cg/ap-compliance.html

According to Coverage SLE, Asymmetry Downlink classifier tracks a client that transmits at lower data rate than AP to which it is connected.So the correct answer is A.Asymmetry Downlink

The impact of adding more SSIDs to a radio is beacon overhead.So,the correct answer is A.beacon overhead

According to the Cisco Catalyst 9800 Series Wireless Controller Software Configuration Guide1, a config template is a configuration object that can be used to apply consistent WxLAN and WLAN policies across all sites within the same organization. A config template can be applied to a site group, which is a collection of sites that share common attributes.

References: https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-2/config-guide/b_wl_17_2_cg/config_templates.html

The AI VALIDATED status update means that the issue was opened and Marvis confirms it has been closed.

According to the Marvis Virtual Network Assistant Datasheet1, the AI-VALIDATED status update means that the issue was opened and Marvis confirms it has been closed. This status indicates that Marvis has verified that the issue is no longer present and the root cause has been resolved.

References: https://www.juniper.net/us/en/products/cloud-services/marvis-virtual-network-assistant-datasheet.html

Basic data rates are the required data rates that all devices on a wireless network must support in order to connect to the network. These rates are used for management and control frames and can affect the performance of the network.

According to the Lecture 3 - Radio Frequency and Antenna Fundamentals - Part 2 document2, basic data rates are required data rates that all devices must support to communicate on a WLAN.

References: http://faculty.georgebrown.ca/~jolenewa/courses/comp3049-intermediate-wirel/lecture-3—radio-frequency.pdf