HPE2-W06 Aruba Data Center Network Specialist Exam Questions and Answers

Can you attach this type of ArubaOS-CX interface to a VRF?

Solution:a loopback Interface

You are configuring Ethernet Ring Protection Switching (ERPS) on an ArubaOS-CX switch. Is this a guideline for configuring timers?

Solution:The guard interval is set in units ofseconds and is used to prevent frequent topology changes due to a link going up and down.

Refer to the exhibit.

:The company wants AtubaOS-CX switches to provide VXLAN services for several VMs and servers, as shown in the exhibit. Hypervisors will not run VXLAN for this solution. Is this part of a valid configuration to meet the requirements?

Solution: Attach VNIs 5010 and 5020 to interface 1/1/3 on Switch-2.

You plan to use multi-protocol BGP to implement dynamic VRF route leaking on an ArubaOS-CX switch.

Is this a rule for the setup?

Solution:You can only leak routes between up to three VRFs.

Is this how you should position switches in the ArubaOS-CX portfolio tor data center networks?

Solution:Deploy Aruba 83xx switches as core switches for very large three-tier data center networks.

Your customer is using Nutanix AHV and they need a network orchestration tool to simplify network provisioning. Is this operation supported whenAruba Fabric Composer (AFC) is integrated with Nutanix?

Solution:Automated configuration of Layer 3 MP-BGP protocol on leaf switches

Refer to the exhibit.

You want to enable devices in VRF B and VRF C to reach shared resources in VRF A. is this a valid strategy for meeting this goal?

Solution:Place ad threeVRF$ in the same OSPF process on Switch-1.

Refer to theexhibits.

Is this how the switch handles the traffic?

Solution: A frame with destination MAC address, 00:50:56:15:16:28, arrives with a VLAN 10 tag on 1/1/1 on Switch-1. Switch-1 encapsulates the frame with VXLAN and an IP header destined to 192.168.1.2.