The route selection tool route-policy" can set and filter BGP attributes based on pre-defined conditions. Therefore, this tool is often used to define policies towards a BGP peer or during route generation.
Which of the following statements regarding the Reverse Path Forwarding (RPF) mechanism are
true? (Select 2 answers)
By default, the cost of an OSPF interface is calculated based on the bandwidth. The formula to calculate the cost is reference bandwidth/interface bandwidth.
Which of the following statements regarding multicast MAC addresses are true (Select 3 answers)
Which of the following BGP attributes can prevent routing loops? (Select 3 answers)
Which of these statements is true when configuring MD5 authentication between BGP peers?
Which of following BGP attributes is used to define a set of prefixes with same properties?
The Internet Group Management Protocol (IGMP) runs between hosts and their immediately neighboring multicast routers.
Whenever changes occur in the BGP routing table, a BGP Speaker advertises all the optimal routes in the BGP routing table to its peers.
ABR of a Stub area does not flood Type-5 and Type-4 LSAs into the area. Therefore, the Stub area does not have the external AS routing capability. ABRs of the Stub area generate a default route into the area which enables packet forwarding to external destinations.
Which statements regarding the local preference attribute are true? (Select 2 answers)
Which of the following statements regarding the IP address 224.0.0.1 are correct? (Select 2 answers)
What command must be configured to establish a BGP connection between indirectly connected EBGP peers?
Which of the following multicast protocols can generate multicast distribution trees?
Which of the following route entries match the IP-Prefix defined below?
ip ip-prefix test index 10 permit 192.168.0.0 16 greater-equal 24 less-equal 28
(Select 2 answers)
In a route-policy, which BGP attributes can be used to define apply clauses? (Select 3 answers)
A company has four departments. Department A has 80 PCs, Departments B and C both have 20 PCs, and Department D has 30 PCs. Assuming the IP address 192.168.1.0/x is used, which of the following statements are true if the VLSM technology is employed for subnetting? (Select 2 answers)
Which of the following elements together uniquely identify a LSA? (Select 3 answers)
Given a Class B network 155.16.0.0 with the mask 255.255.255.192, what is the maximum number of subnets that can be created, and what is the maximum number of hosts available within each created subnet?
The Origin attribute of the BGP routes injected with the network command are considered IGP.
Which of these statements is false when using the import-route command to import routes into BGP?
Which of the following protocols support the multicast ASM service model? (Select 2 answers)
BGP is an exterior gateway protocol which runs between ASs. It focuses on the control of route propagation and selection of optimal routes rather than discovery and calculation of routes.
A OSPF network may be structured, or subdivided into routing areas. Such routing areas are a set of network segments.