170-010 Brocade Certified vRouter Engineer Questions and Answers

vyatta@vyatta:~$ show interfaces

Codes: S - State, L - Link, u - Up, D - Down, A - Admin Down

Interface IP Address S/L Description

--------- ---------- --- -----------

eth0 172.24.42.52/24 u/u

eth1 192.168.12.2/24 u/u

eth2 192.168.23.2/24 u/u

eth3 192.168.128.2/24 u/u

lo 127.0.0.1/8 u/u

::1/128

vyatta@vyatta:~$ show dns forwarding nameservers

-----------------------------------------------

Nameservers configured for DNS forwarding

-----------------------------------------------

172.24.42.1 available via 'system'

216.134.160.13 available via 'system'

Based on the output shown, which two statements are true? (Choose two.)

Which command line displays the output of an OSPF protocol monitoring session on your screen?

Data is being transmitted from host A to host B.

If you were to capture a frame at the point indicated in the exhibit, what would the source MAC address be?

Which three configuration parameters are auto-detected on a vRouter Ethernet port? (Choose three.)

Which two steps are required to enable logging of NAT traffic? (Choose two.)

vyatta@vyatta:~$ show dhcp server leases

IP address Hardware Address Lease expiration Pool Client Name

---------- ---------------- ---------------- ---- -----------

10.224.7.40 00:04:f2:02:84:49 2013/06/22 17:46:20 ClientLAN

10.224.7.41 d4:be:d9:1b:ed:9e 2013/06/22 20:27:26 ClientLAN PC-HR-34

vyatta@vyatta:~$ show interfaces

Codes: S - State, L - Link, u - Up, D - Down, A - Admin Down

Interface IP Address S/L Description

--------- ---------- --- -----------

eth0 192.168.200.254/24 u/u

eth1 192.168.100.1/24 u/u

eth2 10.224.7.1/25 u/u

eth3 172.24.42.1/24 u/u

lo 127.0.0.1/8 u/u

::1/128

Based on the output shown, which statement is true?

By default, what information is stored in the Brocade Vyatta vRouter system log? (Choose two.)

You are experiencing slow system throughput and suspect that you are running out of system memory.

Which command would you use to confirm this?

Which three commands should be used to modify a firewall rulebase? (Choose three.)